Subaru Legacy BN/BS (2015-2019) Service Manual: 34

Subaru Legacy BN/BS (2015-2019) Service Manual / Cruise control system (diagnostics) / Diagnostic procedure with cancel code / 34

The vehicle has been driven at a speed higher than set speed for a long time (approximately 10 minutes) during cruise driving.

This cancel code is detected when driving for a long period of time at a speed higher than appropriate for cruise control setting by operating the accelerator pedal.

Perform the cruise control setting operation again. If the cancel code is not detected, it is normal.

35

Detected when it is impossible to perform the vehicle speed feedback.Set vehicle speed cannot be kept for some reasons (steep uphill, unreleased parking brake, etc.) during cruise driving.Cancel code ...

32

Detected when the vehicle speed is out of the system controllable range.Increase vehicle speed high enough to allow the cruise control to function, and then perform setting operation again.If cancel c ...

Other materials:

Installation
1. Apply liquid gasket to the mating surface of cylinder block shown in the figure.NOTE:• Install within 5 min. after applying liquid gasket.• Do not apply liquid gasket excessively. If too much is applied, remove any liquid gasket that is squeezed out.Liquid gasket:THREE BOND 1217G (K08 ...