Honda Civic manuals

Subaru Legacy Owners Manual: Arming the system

NOTE

  •  The system can be armed even if the engine hood, the windows and/or moonroof are open. Always make sure that they are fully closed before arming the system.
  •  When arming the system, if any of the doors or the rear gate/trunk lid is not fully closed, an electronic chirp sounds five times, the hazard warning flashers flash five times to alert you that the doors (or the rear gate/trunk lid) are not properly closed. When you close the door, doors will automatically lock and the system will automatically arm in 30 seconds.
  •  The 30-second standby time can be eliminated if you prefer. Have it performed by your SUBARU dealer.
  •  For Legacy, if you open the trunk using the access key/remote transmitter's " " button in the surveillance state (or the standby state), the system will be temporarily placed in a standby state. The system will go back to the surveillance state in 30 seconds upon locking the trunk.
  •  The system is in the standby state for a 30-second period before arming the system. The security indicator light will flash at short intervals during this period.
  •  If any of the following actions is done during the standby period, the system will not switch to the surveillance state.
  •  Doors (including the rear gate/ trunk lid) are unlocked using the access key/remote transmitter.
  •  Doors (including the rear gate/ trunk lid) are unlocked using the keyless access function (models with "keyless access with pushbutton start system").
  •  Any door (including the rear gate/ trunk lid) is opened.
  •  The ignition switch is turned to the "ON" position (models without "keyless access with push-button start system").
  •  Push-button ignition switch is turned to the "ACC" position (models with "keyless access with pushbutton start system").
If you have accidentally triggered the alarm system
To stop the alarm Perform any of the following operations.  Press any button on the access key/ remote transmitter.  Turn the ignition switch to the "ON" position (models without ...

To arm the system using the access key/remote transmitter
Close all windows and the moonroof (if equipped).  Remove the key from the ignition switch (models without "keyless access with push-button start system")/turn the push-button igniti ...

Other materials:

Inspection
1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.2. CHECK RELAY1. Check the resistance between relay terminals.Terminal No.Inspection conditionsStandardCircuit1 — 2Always1 M- or more1 — 2Apply battery voltage between terminals 4 and 3.Less than 1 ...

© 2017-2019 Copyright www.sulegacy.com