Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly

Replacement

1. Slowly remove the protector UPR from the end of right and left protectors.CAUTION:• Be careful not to damage the surface of garnish assembly during operation.• Do not reuse the protecto ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the rear gate trim. Rear Gate Trim > REMOVAL3. Remove the garnish assembly - rear gate.(1) Remove the bolts and clips, and remove ...

Other materials:

Installation
1. Install the purge control solenoid valve, and connect the connector and vacuum hose to the purge control solenoid valve.NOTE:Connect the vacuum hose as shown in the figure.(a)To intake manifold(b)To fuel pipe Tightening torque:19 N·m (1.9 kgf-m, 14.0 ft-lb)2. Install the air intake boot. ...