Honda Civic manuals

Subaru Legacy Service Manual: Basic diagnostic procedure procedure

Subaru Legacy Service Manual / Combination meter (diagnostics) / Basic diagnostic procedure procedure

STEPCHECKYESNO

1.PERFORM CUSTOMER INTERVIEW.

Using the Check List for Interview, ask the customer the condition of how trouble occurs. Check List for Interview > CHECK

Did you interview the customer-

Basic Diagnostic Procedure > PROCEDURE

Interview the customer. Check List for Interview > CHECK

2.CHECK CAN COMMUNICATION.

Read the DTC of the CAN system using the Subaru Select Monitor. Read Diagnostic Trouble Code (DTC) > OPERATION

Is DTC displayed-

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC) > LIST

Basic Diagnostic Procedure > PROCEDURE

3.CHECK COMBINATION METER.

Using the Subaru Select Monitor, read DTC of combination meter. Read Diagnostic Trouble Code (DTC)

Is DTC displayed-

Record DTC and time stamp, and perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC) > LIST

For time stamp, refer to “LAN SYSTEM”. General Description > CAUTION

Basic Diagnostic Procedure > PROCEDURE

Basic Diagnostic Procedure > PROCEDURE

4.CHECK COMBINATION METER.

Check the operation of combination meter. System Operation Check Mode

Is it operating normally-

System is normal.

Replace the combination meter. Combination Meter

5.PERFORM DIAGNOSIS.

1) Perform the Clear Memory Mode. Clear Memory Mode

2) Perform the Inspection Mode. Inspection Mode

3) Using the Subaru Select Monitor, read DTC of combination meter. Read Diagnostic Trouble Code (DTC)

Is DTC displayed-

Perform diagnosis according to the DTC.

Finish the diagnosis.

Combination meter (diagnostics)
...

Check list for interview check
• Inspect the following items regarding the vehicle’s state.• Print out this page for interviewing customers.Combination Meter Check List for Interview ...

Other materials:

Installation
CAUTION:• Install the bumper face - front so that the front end of the under cover (b) comes inside the bumper face - front (a).• Before installing the bumper face, match the claws on the bracket - front bumper with the engaging position of flange section on the bumper face side. If the ...

© 2017-2020 Copyright www.sulegacy.com