Honda Civic manuals

Subaru Legacy Service Manual: Caution

When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.

When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.

Some vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.

Use SUBARU genuine grease, the recommended or equivalent. Do not mix grease etc. of different grades or manufacturers.

Be sure to tighten fasteners including bolts and nuts to the specified torque.

Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.

Apply grease onto sliding or revolving surfaces before installation.

Be sure that the surface of brake disc, brake pad or brake shoe is free from grease or oil.

Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.

Do not secure a part in a vise directly. Place cushioning materials such as wood blocks, aluminum plates, or waste cloth between the part and the vise.

Specification
NOTE:Refer to “PARKING BRAKE” for parking brake specifications. General Description > SPECIFICATION1. FRONT DISC BRAKEItemSpecificationSize16-inch17-inchTypeFloating 2-POT piston typeVent ...

Preparation tool
1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — (Newly adopted tool)SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed op ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the center grille assembly. Air Vent Grille > REMOVAL3. Remove the heater control assembly. Control Panel > REMOVAL4. Remove the audio assembly.(1) Remove the screws and clips.(2) Disconnect the connector and remove the audio as ...

© 2017-2020 Copyright www.sulegacy.com