Honda Civic manuals

Subaru Legacy Service Manual: Caution

When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.

Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.

When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.

Some vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.

Use SUBARU genuine grease, the recommended or equivalent. Do not mix grease etc. of different grades or manufacturers.

Be sure to tighten fasteners including bolts and nuts to the specified torque.

Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.

Apply grease onto sliding or revolving surfaces before installation.

Be sure that the surface of brake disc, brake pad or brake shoe is free from grease or oil.

Do not secure a part in a vise directly. Place cushioning materials such as wood blocks, aluminum plates, or waste cloth between the part and the vise.

When the suspension-related components have been removed or replaced, perform “VDC sensor midpoint setting mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT

Specification
1. PROPELLER SHAFTModelAll modelsPropeller shaft typeEDJFront propeller shaft joint-to-joint length: L1mm (in)CVT (TR580)675.5 (26.59)CVT (TR690)578 (22.76)6MT735.5 (28.96)Rear propeller shaft joint-t ...

Preparation tool
1. SPECIAL TOOLILLUSTRATIONPart No.DESCRIPTIONREMARKS20099PA010INSTALLER & REMOVER• Used for replacing the bushing - trailing link of the housing assembly - rear axle.• Used together with ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the heater control assembly.(1) Release the clips and claws, then detach the control module cover.(2) Release the screws and clips, then detach the heater control assembly.CAUTION:• Insert a flat tip screwdriver wrapped with ...

© 2017-2024 Copyright www.sulegacy.com