Subaru Legacy BN/BS (2015-2019) Service Manual: Check list for interview check

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission (diagnostics) / Check list for interview check

Check the following items when a problem has occurred.

NOTE:

Use copies of this page for interviewing customers.

Customer’s name
Date of purchase
Date of repair
Transmission model	Transmission		V.I.N.
Odometer reading	km (miles)
Frequency	Continuous Intermittent ( times/day)
Weather	Fine Cloudy Rainy Snowy Other ( )
Place	Highland Suburbs Inner city Uphill Downhill Rough road Other ( )
Ambient air temperature	Hot Warm Cool Cold
Vehicle speed	km/h (MPH)
AT OIL TEMP light	Blinks continuously		Does not blink
Select lever position	P R N D Manual mode
Driving condition	Not affected At racing While decelerating	At starting While accelerating While turning ( RH/ LH)		While idling When cruising (Vehicle speed km/h) Immediately after starting the engine
Manual mode	ON OFF
Symptoms	Vehicle does not move ( Any position Particular position)
	Vehicle does not move (no load racing condition as in N range)
	Vehicle does not move (engine speed does not increase, felt as stall condition)
	Noise or vibration (Describe concretely: )
	Shock felt at N > D selection ( seconds after shifting, when engine cold or after warm-up)
	Shock felt at N > R selection ( seconds after shifting, when engine cold or after warm-up)
	Shifting is wrong (Describe concretely: )
	Shock or judder during driving
	Fails to accelerate.
	Engine speed increases abruptly during driving
	Shock or judder during standing start
	Select lever does not move
	Other ( )

Basic diagnostic procedure procedure

STEPCHECKYESNO1.CHECK PRE-INSPECTION.1) Ask the customer when and how the trouble occurred using the interview check list. Check List for Interview2) Before performing diagnostics, check the followin ...

Clear memory mode operation

1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System Check».4. O ...

Other materials:

Installation
CAUTION:Be careful not to snag the harness.1. Install each connector and the drain tube - sunroof.Tightening torque:Connector holder: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb)Ground bolt: 13 N·m (1.3 kgf-m, 9.6 ft-lb)2. Install the cover side sill - front and the front cover - side sill.3. Instal ...