Honda Civic manuals

Subaru Legacy Service Manual: Clear memory mode operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Combination Meter» and then select «Enter».

5. On «Select Function» display, select «DTC».

6. On «DTC» display, select «Clear Memory».

NOTE:

For detailed operation procedures, refer to “Application help”.

Check list for interview check
• Inspect the following items regarding the vehicle’s state.• Print out this page for interviewing customers.Combination Meter Check List for Interview ...

Control module i o signal electrical specification
Terminal No.ContentsMeasuring conditionStandard1 ←> Chassis groundBattery power supplyAlways8 — 16 V2 ←> Chassis groundIgnition power supply (main)Ignition switch ON8 — 16 V3 — — ...

Other materials:

Removal
1. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) Carefully pull up the front of collector cover at two positions (B) while moving it forward.2. Disconnect the ground terminal from battery sensor. NOTE3. Loosen the clamp (A) securing the air in ...

© 2017-2020 Copyright www.sulegacy.com