Honda Civic manuals

Subaru Legacy Service Manual: Connecting rod specification

Subaru Legacy Service Manual / Mechanical(h6do) / Connecting rod specification

Refer to “Cylinder Block” for removal and installation procedures of connecting rod. Cylinder Block > REMOVAL Cylinder Block > INSTALLATION

Compression inspection
CAUTION:After warming-up, engine becomes very hot. Be careful not to burn yourself during measurement.NOTE:• Before checking the compression pressure, the compression condition of each cylinder ...

Crankshaft specification
Refer to “Cylinder Block” for removal and installation procedures of the crankshaft. Cylinder Block > REMOVAL Cylinder Block > INSTALLATION ...

Other materials:

Installation
1. TOUCH SENSOR UPR1. Install the power rear gate touch sensor UPR.(1) Clean the bracket surface of the touch sensor UPR to remove dust and dirt fully.(2) Using a sponge, apply primer to the bracket surface of the touch sensor UPR that is not covered with masking tape.CAUTION:• Do not apply pr ...

© 2017-2019 Copyright www.sulegacy.com