Honda Civic manuals

Subaru Legacy Owners Manual: CVT models

CAUTION If you restart the engine while the vehicle is moving, shift the select lever into the "N" position. Do not attempt to place the select lever of a moving vehicle into the "P" position.
  1. Apply the parking brake.
  2.  Turn off unnecessary lights and accessories.
  3.  Shift the select lever to the "P" or "N" position (preferably "P" position). The starter will only operate when the select lever is at the "P" or "N" position.
  4.  Turn the ignition switch to the "ON" position and check the operation of the warning and indicator lights. Refer to "Warning and indicator lights" .
  5. Turn the ignition switch to the "START" position without depressing the accelerator pedal. Release the key immediately after the engine has started.

    If the engine does not start, perform the following procedure.

(1) Turn the ignition switch to the "LOCK" position and wait for at least 10 seconds. After checking that the parking brake is applied, turn the ignition switch to the "START" position while depressing the accelerator pedal slightly (approximately a quarter of the full stroke). Release the accelerator pedal as soon as the engine starts.
(2) If this fails to start the engine, turn the ignition switch back to the "LOCK" position and wait for at least 10 seconds. Then fully depress the accelerator pedal and turn the ignition switch to the "START" position. If the engine starts, quickly release the accelerator pedal.
(3) If this fails to start the engine, turn the ignition switch again to the "LOCK" position. After waiting for 10 seconds or longer, turn the ignition switch to the "START" position without depressing the accelerator pedal.
(4) If the engine still does not start, contact your nearest SUBARU dealer for assistance.

  1.  Confirm that all warning and indicator lights have turned off after the engine has started. The fuel injection system automatically lowers the idle speed as the engine warms up.

While the engine is warming up, make sure that the select lever is at the "P" or "N" position and that the parking brake is applied.

MT models
Apply the parking brake.  Turn off unnecessary lights and accessories.  Depress the clutch pedal to the floor and shift the shift lever into neutral. Hold the clutch pedal to the ...

Stopping the engine
WARNING Do not stop the engine when the vehicle is moving. This will cause loss of power to the power steering and the brake booster, making steering and braking more difficult. ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL3. Remove the cowl panel - side and the cowl panel assembly. Cowl Panel > REMOVALCAUTION:Before removing the cowl panel, use an air blower and nylon brush to sweep gr ...

© 2017-2019 Copyright www.sulegacy.com