Honda Civic manuals

Subaru Legacy Owners Manual: Disabling functions

By operating the access key

If you have registered a PIN code for PIN Code Access, you can disable the keyless access function by operating the access key. For details about registering a PIN code, refer to "Registering a PIN code" .

  1.  Open the driver's door.

Disabling functions

  1. Rotate the lock lever forward.

Disabling functions

  1. Press and hold the "  " button and " " button on the access key simultaneously for more than 5 seconds.

A chirp sound will be heard, and the function will be disabled.

By operating the driver's door

  1.  Sit in the driver's seat, and close the door.

By operating the driver's door

  1. Push the rear side (unlock side) of the power door locking switch.
  2.  Within 5 seconds after step 2 is performed, open the driver's door.
  3.  Within 5 seconds after step 3 is performed, push the rear side (unlock side) of the power door locking switch twice while the door is open.
  4.  Within 10 seconds after step 4 is performed, close and open the driver's door twice.
  5.  Within 10 seconds after step 5 is performed, push the rear side (unlock side) of the power door locking switch twice while the door is open.
  6.  Within 10 seconds after step 6 is performed, close and open the driver's door once.
  7.  Within 5 seconds after step 7 is performed, close the door.

A chirp sound will be heard, and the functions will be disabled.

NOTE In steps 4 and 6, press the power door locking switch firmly. If the switch is not pressed firmly, the functions may not be disabled.

Selecting audible signal operation
Using an electronic chirp, the system will give you an audible signal when the doors are locked or unlocked. If desired, you can turn the audible signal off by operating the multi information disp ...

Enabling functions
When the procedure to disable the functions is performed again, a chirp sound will be heard, and the functions are enabled. NOTE  The keyless access function will be enabled only if you ...

Other materials:

Inspection
1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 3Switch OFF1 M- or moreSwitch ONLess than 1 -2 — 3Switch doorLess than 1 -2. Apply battery voltage between the connector terminals to check the lighting condition of ...

© 2017-2020 Copyright www.sulegacy.com