Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc u0101 lost communication with tcm

NOTE:

For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure

1. OUTLINE OF DIAGNOSIS

Detect malfunction of CAN communication.

Judge as NG when CAN communication failure between TCM, VDC CM and combination meter has occurred.

2. COMPONENT DESCRIPTION

(Common Specifications)

CAN Protocol 2.0 B (Active)

Frame Format: 11 Bit ID Frame (Standard Frame)

Conforms to ISO11898

Communication Speed: 500 kbps

3. EXECUTION CONDITION

Secondary Parameters

Execution condition

Battery voltage

≥ 10.9 V

4. GENERAL DRIVING CYCLE

Always perform the diagnosis continuously.

5. DIAGNOSTIC METHOD

Judge as NG when the following conditions are established.

Judgment Value

Malfunction Criteria

Threshold Value

Data from control modules connected to CAN

None

Time Needed for Diagnosis: 500 ms

Malfunction Indicator Light Illumination: Illuminates as soon as a malfunction occurs.

Dtc p0125 insufficient coolant temperature for closed loop fuel control
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:Engine does not return to idle.CAUTION:After servicing or replacing faulty parts, perform Clear Me ...

Dtc u1712 lost lin communication with battery "1" monitor module
NOTE:For the diagnostic procedure, refer to DTC U0077. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0073 CONTROL MODULE COMMUNICATION BUS OFF1. OUTLINE OF DIAGNOSISDetect malfunctio ...

Other materials:

Disassembly
1. Place alignment marks on the shaft and outer race.2. Remove the PTJ boot band and boot.CAUTION:Be careful not to damage the boot.3. Remove the snap ring from PTJ outer race.4. Remove the PTJ outer race from shaft assembly.5. Wipe off grease.CAUTION:The grease is a special type of grease. Do not m ...

© 2017-2024 Copyright www.sulegacy.com