Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Ebd warning light, abs warning, vdc off indicator light, vdc warning light and vdc indicator light do not come on

Subaru Legacy BN/BS (2015-2019) Service Manual / Vehicle dynamics control (vdc) (diagnostics) / Warning light illumination pattern / Ebd warning light, abs warning, vdc off indicator light, vdc warning light and vdc indicator light do not come on

DETECTING CONDITION:

Defective combination meter

TROUBLE SYMPTOM:

When the ignition switch is turned to ON (engine OFF), brake warning light (EBD warning light), ABS warning light, VDC OFF indicator light, and VDC warning light & VDC indicator light do not illuminate.

NOTE:

When pressing the VDC OFF switch for 30 seconds or more, the VDC OFF indicator light goes off and cannot operate any more. When turning the ignition switch from OFF to ON, the OFF operation enabled status is restored.

STEPCHECKYESNO

1.CHECK OTHER INDICATOR LIGHT.

Turn the ignition switch to ON.

Does other indicator light illuminate soon after “ON”-

Warning Light Illumination Pattern > EBD WARNING LIGHT, ABS WARNING, VDC OFF INDICATOR LIGHT, VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT COME ON

Check the combination meter. Combination Meter System > OPERATION

2.CHECK VDCCM.

When the engine does not start, display the current data of VDCCM using Subaru Select Monitor.

Immediately after the ignition switch is turned to ON, is the «EBD Warning Light» ON-

Warning Light Illumination Pattern > EBD WARNING LIGHT, ABS WARNING, VDC OFF INDICATOR LIGHT, VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT COME ON

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)

3.CHECK VDCCM.

When the engine does not start, display the current data of VDCCM using Subaru Select Monitor.

Immediately after the ignition switch is turned to ON, is the «ABS Warning Lamp» ON-

Warning Light Illumination Pattern > EBD WARNING LIGHT, ABS WARNING, VDC OFF INDICATOR LIGHT, VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT COME ON

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)

4.CHECK VDCCM.

When the engine does not start, display the current data of VDCCM using Subaru Select Monitor.

Immediately after the ignition switch is turned to ON, is the «VDC Warning Lamp» ON-

Check the combination meter. Combination Meter System > OPERATION

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)

Abs warning light does not go off
DETECTING CONDITION:• Defective combination meter• Defective engine• Defective CAN communicationTROUBLE SYMPTOM:When starting the engine, the ABS warning light is kept on.STEPCHECKYE ...

Electronic parking brake indicator light, hill hold indicator light do not go off
DETECTING CONDITION:Defective combination meterTROUBLE SYMPTOM:• When starting the engine, the electronic parking brake operation indicator light does not go off even when the electronic parking ...

Other materials:

Dtc b1012 battery backup power supply
DTC DETECTING CONDITION:Voltage failure caused by poor contact of battery power supply backup circuitsBAT (back-up) voltage was outside the range of 8.3 — 16.7 V, when the BAT (back-up) power supply was ON.Time Needed for Diagnosis:40 s or moreTROUBLE SYMPTOM:Illuminations for the keyless entry, m ...

© 2017-2024 Copyright www.sulegacy.com