Honda Civic manuals

Subaru Legacy Service Manual: Electronic parking brake indicator light, hill hold indicator light do not come on

Subaru Legacy Service Manual / Vehicle dynamics control (vdc) (diagnostics) / Warning light illumination pattern / Electronic parking brake indicator light, hill hold indicator light do not come on

DETECTING CONDITION:

Defective combination meter

TROUBLE SYMPTOM:

When the ignition switch is ON (engine OFF), the electronic parking brake operation indicator light does not illuminate even when the electronic parking brake switch is operated.

When the ignition switch is ON (engine OFF), the hill hold indicator light does not illuminate even when the hill hold switch is operated.

STEPCHECKYESNO

1.CHECK OTHER INDICATOR LIGHT.

Turn the ignition switch to ON. (Engine OFF)

Do other indicator lights illuminate-

Warning Light Illumination Pattern > ELECTRONIC PARKING BRAKE INDICATOR LIGHT, HILL HOLD INDICATOR LIGHT DO NOT COME ON

Check the combination meter. Combination Meter System > OPERATION

2.READ DTC.

Read the DTC. Read Diagnostic Trouble Code (DTC)

Is DTC displayed-

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)

Warning Light Illumination Pattern > ELECTRONIC PARKING BRAKE INDICATOR LIGHT, HILL HOLD INDICATOR LIGHT DO NOT COME ON

3.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system. Basic Diagnostic Procedure

Is there any fault in LAN system-

Perform the diagnosis according to DTC for LAN system. List of Diagnostic Trouble Code (DTC)

Warning Light Illumination Pattern > ELECTRONIC PARKING BRAKE INDICATOR LIGHT, HILL HOLD INDICATOR LIGHT DO NOT COME ON

4.CHECK COMBINATION METER.

Check the combination meter. Combination Meter System > OPERATION

Is combination meter OK-

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)

Replace the combination meter. Combination Meter

Electronic parking brake indicator light, hill hold indicator light do not go off
DETECTING CONDITION:Defective combination meterTROUBLE SYMPTOM:• When starting the engine, the electronic parking brake operation indicator light does not go off even when the electronic parking ...

Wheel and tire system
...

Other materials:

Installation
1. Install the ball joint into the housing assembly - front axle.CAUTION:• Do not apply grease to the tapered portion of ball stud.• Before tightening, make sure the bottom surface of the housing assembly - front axle and the stepped section of ball joint are in contact.(1)Bottom surface ...

© 2017-2019 Copyright www.sulegacy.com