Subaru Legacy BN/BS (2015-2019) Owners Manual: Front seatbelts

Subaru Legacy BN/BS (2015-2019) Owners Manual / Seat, seatbelt and SRS airbags / Seatbelts / Fastening the seatbelt / Front seatbelts

Adjust the seat position: Driver's seat: Adjust the seatback to the upright position. Move the seat as far from the steering wheel as practical while still maintaining full vehicle control.
Front passenger's seat: Adjust the seatback to the upright position. Move the seat as far back as possible.
Sit well back in the seat.
Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted.

If the belt stops before reaching the buckle, return the belt slightly and pull it out more slowly.
If the belt still cannot be unlocked, let the belt retract slightly after giving it a strong pull, then pull it out slowly again.

Front seatbelts

Insert the tongue plate into the buckle until you hear a click.

Front seatbelts

To make the lap part tight, pull up on the shoulder belt.
Place the lap belt as low as possible on your hips, not on your waist.

Fastening the seatbelt

WARNING Never use a belt that is twisted or reversed. In an accident, this can increase the risk or severity of injury. Keep the lap belt as low as possible on y ...

Adjusting the front seat shoulder belt anchor height

The shoulder belt anchor height should be adjusted to the position best suited for the driver/front passenger. Always adjust the anchor height so that the shoulder belt passes over the middle ...

Other materials:

Disassembly
NOTE:When replacing the coupling sleeve and synchronizer hub, replace them as a set. Because these must engage at the specified point, avoid disassembly as much as possible. If it is necessary to disassemble, mark the engaging points on the splines beforehand.1. Put vinyl tape around the main shaft ...