Repair or replace any faulty hoses, pipes, clamps, and washers found in the inspection below. • Check for CVTF leaks in joints at the transmission, CVTF cooler (air cool), pipes, and hoses. • Check the clamp for deformation. • Lightly bend the hose and check for cracks in the surface or other damages. • Pinch the hose with your fingers and check for poor elasticity. Also check for poor elasticity in the parts where the clamp was installed by pressing with your fingernail. • Check for peeling, cracks, and deformation at the tip of the hose. |
Dtc p0452 evap system (cpc) pressure sensor/switch circuit low
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...