Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.

Inspection conditions

Standard

1 — 2

Switch OFF

1 M- or more

Switch ON

Less than 1 -

2 — 3

Switch door

Less than 1 -

2. Replace the light assembly - luggage room if the inspection result is not within the standard value.

Removal
NOTE:Do not remove the luggage room light if removing the bulb only.1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the luggage room light.(1) Release the claws.(2) Disconnect th ...

Installation
1. Install the lens and bulb.CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.2. Install the light assembly - luggage room.3. Connect the ground termin ...

Other materials:

Dtc p0420 catalyst system efficiency below threshold bank 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Engine stalls.• Idle mixture is out of specifications.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode ...

© 2017-2024 Copyright www.sulegacy.com