Honda Civic manuals

Subaru Legacy Service Manual: Inspection

Symptoms

Inspection order

All power windows do not operate.

(1) Check the fuse.

(2) Check the power window relay.

(3) Check the wiring harness.

Particular window does not operate.

(1) Check the fuse.

(2) Check the switch - power window main.

(3) Check the switch - power window sub.

(4) Check the power window motor.

(5) Check the wiring harness.

“Window Lock” does not operate.

Check the switch - power window main.

Driver’s side window moves slightly (approx. 20 mm (0.79 in)).

(1) Check the motor - front.

(2) Check the switch - power window main.

(3) Check the wiring harness.

Driver’s side window moves slightly (approx. 50 mm (1.97 in)). (This status is not a failure.)

Perform reset operation A. Power Window System > OPERATION

Driver’s side window does not close completely. (Using AUTO UP allows the window to fully close first and then move in reverse resulting in slightly opening.)

Perform reset operation B. Power Window System > OPERATION

Wiring diagram
Refer to “Power Window System” in the wiring diagram. Power Window System > WIRING DIAGRAM ...

Operation
1. RESET OPERATION A1. Sit in the driver’s seat and close the door.2. Turn the ignition switch to ON.3. Operate the switch - power window main to open the glass assembly - front door halfway.4. ...

Other materials:

Installation
1. Apply CVTF to the seal ring and attach it to the seal ring groove of transfer clutch assembly.NOTE:• Use new seal rings.• When installing the seal rings, do not expand the seal rings too much.2. Install the transfer clutch assembly.3. Select the thrust needle bearing. Rear Drive Shaf ...

© 2017-2020 Copyright www.sulegacy.com