Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. PRE-COLLISION BRAKE OFF SWITCH/LANE DEPARTURE WARNING OFF SWITCH 1. Install the pre-collision brake OFF switch or the lane departure warning OFF switch. 2. Install the cover assembly - instrument panel LWR driver. 3. Connect the ground terminal to battery sensor. NOTE 2. EyeSight STEERING SWITCH NOTE: For the operation procedures for the EyeSight steering switch, refer to “CRUISE CONTROL SYSTEM” section. Cruise Control Command Switch > INSTALLATION |
Inspection
1. PRE-COLLISION BRAKE OFF SWITCH/LANE DEPARTURE WARNING OFF SWITCH1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard6 — 8 ...
Front suspension
...
Other materials:
Dtc p0451 evap system (cpc) pressure sensor/switch circuit range/performance
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.STEPCHECKYESNO1.CHECK FOR ANY OTHER DTC ON DISPLAY.Is an ...
