Honda Civic manuals

Subaru Legacy Service Manual: Operation

Lane Departure Prevention Deactivate Code(s) Display: The lane departure prevention deactivate code is output, when the lane keep (lane departure prevention) is canceled during the operation or the standby state is canceled.

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «EyeSight» and select «Enter».

5. On «Select Function» display, select «Cancel Code».

6. On «Cancel Code» display, select «Lane Departure Prevention Assist Deactivate Code(s) Display».

NOTE:

For detailed operation procedures, refer to “Application help”.

Up to eight codes can be stored. When more than eight codes are output, the oldest code will be deleted to store the latest code.

Stored codes will be cleared by Clear Memory.

For details on lane keep assist codes, refer to List of lane keep assist code. Active Lane Keep System Code(s) Display > OPERATION

Active lane keep system code(s) display
...

List
• List of lane keep assist codeCodeItemContents of diagnosis02Judging Steering Wheel Not HeldDetected when steering wheel operation by the driver is not detected for a predetermined time (approx ...

Other materials:

Dtc p0038 a/f / o2 heater control circuit high bank 1 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...

© 2017-2019 Copyright www.sulegacy.com