To raise: Pull the head restraint up. To lower: Push the head restraint down while pressing the release button on the top of the seatback. To remove: While pressing the release button, pull out the head restraint. To install: Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks. When the rear-center seating position is occupied, raise the head restraint to the extended position. When the rear center seating position is not occupied, lower the head restraint to improve rearward visibility. |
Removal
CAUTION:• Avoid unnecessary removal of parts in order to prevent fluid leakage.• When the VDCCM&H/U components are removed, be sure to perform the installation according to the installation procedures. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > INSTALLATION1. Disconnect ...