Preparation
- Turn off the ignition switch.
- Close all doors (including trunk/rear
gate).
- Press and hold the " "
button on the
access key. Then all doors (including rear
gate) will be locked.
- Keep the " " button
pressed, and
press the following button within 5 seconds
after step 3.
- Legacy: the trunk opener button
- Outback: the rear lock button
- Press and hold the above button for
more than 5 seconds. Then a chirp will
sound.
- Press the " " button
on the access key
while the chirp sounds.
Then the chirp will stop and the preparation
is complete.
NOTE
If you do not press the " " button
on
the access key, the chirp will sound for
30 seconds. In this case, the preparation
for registering a PIN code does not
complete even if the chirp stops.
Registration
For example, to register "32468" as the
PIN code, perform the following procedure.
Legacy:
- Press the trunk opener button three
times.
- After a buzzer (ding) sounds once,
press the trunk opener button twice.
- After a buzzer (ding) sounds once,
press the trunk opener button four times.
- After a buzzer (ding) sounds once,
press the trunk opener button six times.
- After a buzzer (ding) sounds once,
press the trunk opener button eight times.
- Perform steps 1 to 5 again within
approximately 30 seconds after the buzzer
starts sounding intermittently.
- All doors will be unlocked and locked.
Then the PIN code will be registered.
Outback:
- Press the rear lock button three times.
- After a buzzer (ding) sounds once,
press the rear lock button twice.
- After a buzzer (ding) sounds once,
press the rear lock button four times.
- After a buzzer (ding) sounds once,
press the rear lock button six times.
- After a buzzer (ding) sounds once,
press the rear lock button eight times.
- Perform steps 1 to 5 again within
approximately 30 seconds after the buzzer
starts sounding intermittently.
- All doors (including rear gate) will be
unlocked and locked. Then the PIN code
will be registered
NOTE
- Press the trunk opener button/rear
lock button ten times to enter "0".
- Change the PIN code frequently to
protect your vehicle from theft.
- If you have lent your vehicle to
another person, confirm that the PIN
code has not been changed or deleted.
If the PIN code has been changed or
deleted, reregister a new PIN code.
- If you make an error during the
registration procedure, press the "
"
or " " button on the access
key.
Then, start over from the procedure
described in "Preparation".
- To protect your vehicle from theft,
you cannot register "00000" to "99999"
or "12345" as a PIN code.
- Do not register your vehicle license
plate number or simple numbers such
as "11122" or "12121" as a PIN code.
Doing so will increase the risk of
vehicle theft.
- When you try to register "22222",
the registered PIN code will be deleted.
You cannot unlock the doors by PIN
Code Access until a new code is
registered.
- After registering a new PIN code,
make sure that you can unlock the
doors using the PIN code.
- The PIN code cannot be deleted
while the keyless access function is
disabled by operating the access key.
- Reregister the PIN code in the
following case.
- when you forget the PIN code
- when you want to change the PIN
code
|