1. SEDAN MODEL 1. Disconnect the ground terminal from battery sensor. NOTE 2. Remove the trim panel - trunk lid. Trunk Room Trim > REMOVAL 3. Remove the bulb socket and back-up light bulb. CAUTION: Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb. 2. OUTBACK MODEL 1. Disconnect the ground terminal from battery sensor. NOTE 2. Release the claws and remove the bulb inspection cover of rear gate trim. 3. Remove the bulb socket and back-up light bulb. CAUTION: Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb. |
Drive cycle procedure
It is possible to complete diagnosis of the DTC by performing the indicated drive cycle. After the repair for the DTC, perform a necessary drive cycle and make sure the function recovers and the DTC is recorded.1. PREPARATION FOR DRIVE CYCLE1. Check that the battery voltage is 12 V or more and fuel ...