Honda Civic manuals

Subaru Legacy Service Manual: Replacement

1. Remove the rear differential. Rear Differential (T-type) > REMOVAL Rear Differential (VA-type) > REMOVAL

2. Remove the rear differential side oil seal using a ST or screwdriver wrapped with vinyl tape to prevent the side retainer from scratching.

ST 398527700PULLER ASSY

3. Using the ST, install the oil seal to the side retainer.

NOTE:

Use a new oil seal.

Apply differential gear oil to the oil seal lips.

T-type and VA2-type

ST 398437700DRIFT

VA1-type

ST 498447100INSTALLER

4. Install the rear differential. Rear Differential (T-type) > INSTALLATION Rear Differential (VA-type) > INSTALLATION

Rear differential side oil seal
...

Inspection
Check that there is no oil leakage from the side oil seal. If there is any leakage, replace the oil seal. ...

Other materials:

Installation
1. Install the knock sensor to the cylinder block, and connect the connector to the knock sensor.NOTE:• Install the knock sensor connector so that the center of the connector is aligned with the extension line from the cylinder block rib (a).• Make sure that the knock sensor and its conn ...

© 2017-2019 Copyright www.sulegacy.com