Subaru Legacy BN/BS (2015-2019) Service Manual: 32

Subaru Legacy BN/BS (2015-2019) Service Manual / Cruise control system (diagnostics) / Diagnostic procedure with cancel code / 32

Detected when the vehicle speed is out of the system controllable range.

Increase vehicle speed high enough to allow the cruise control to function, and then perform setting operation again.

If cancel code is still detected after setting cruise again, perform the diagnosis for DTC 22.

Refer to DTC 22 for diagnostic procedure.

Diagnostic Procedure with Cancel Code > 22

34

The vehicle has been driven at a speed higher than set speed for a long time (approximately 10 minutes) during cruise driving.This cancel code is detected when driving for a long period of time at a s ...

31

Engine speed signal malfunction is detected.Abnormal increase of engine speed is detected.Gear is placed in 1st (only for MT vehicles) or Reverse position.After driving at the 2nd gear position or hig ...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the power rear gate inner switch.(1) Release the claws and pull out the power rear gate inner switch rearward.NOTE:Insert a flat tip screwdriver wrapped with protective tape into the slit on the left.(2) Disconnect the connector a ...