Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Active test operation

CAUTION:

After executing the system operation check mode, execute the Clear Memory Mode Clear Memory Mode > OPERATION.

NOTE:

*: After replacing ECM or active grille shutter, be sure to perform this procedure.

For detailed operation procedures, refer to “Application help”.

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System Check».

4. On «Select System» display, select «Engine Control System».

5. On «Select Function» display, select «Active Test».

Item

SSM display

Execution condition

Activating the actuator ON/OFF

Activating the fuel pump ON/OFF

Fuel Pump Relay

ON ←> OFF

Ignition switch is ON (engine OFF)

Activating the purge control solenoid valve ON/OFF

CPC Solenoid Valve

ON ←> OFF

Activating the radiator fan relay ON/OFF

Radiator Fan Relay

ON ←> OFF

Activating the ELCM switching valve ON/OFF

ELCM switching valve

ON ←> OFF

Activating the ELCM vacuum pump ON/OFF

ELCM pump

ON ←> OFF

Fuel pump control

Fuel pump OFF operation

OFF Drive

OFF

At idling

Fixing the timing of idle ignition

Fixed Idle Ignition Timing

16.0°

At idling

Idle speed control

Idle Speed Control

500 — 2000 rpm

At idling

Injector control

Stopping fuel injection

(Cylinder selection)

Injection Stop Mode

Injector 1

Injector 2

Injector 3

Injector 4

At idling

Fuel injection amount control

(All cylinders)

Injection Quantity Control

−13 — 20%

At idling

EGR control valve control

EGR Valve Control

0 — 255 STEP

At idling

Alternator control

Alternator control

Low mode

Middle mode

High mode

ExHigh mode

At idling

Active grille shutter control*

Active Grille Shutter Control

Open

Close

Ignition switch is ON (engine OFF)

Experienced 20 seconds or more of the elapsed time after starting engine (when replacing ECM)

Compression measurement

Compression monitor

Ignition switch is ON (engine OFF)

Accelerator pedal is fully depressed

Engine (diagnostics)(h4do)
...

Basic diagnostic procedure procedure
1. ENGINESTEPCHECKYESNO1.CHECK ENGINE START FAILURE.1) Ask the customer when and how the trouble occurred using the interview check list. Check List for Interview > CHECK2) Start the engine.Does the ...

Other materials:

Inspection
1. Lift up the vehicle.2. Remove the filler plug, and then check the gear oil. Replace the gear oil if it is contaminated, deteriorated or cloudy. Differential Gear Oil > REPLACEMENT3. Check that the gear oil level is within −5 mm (−0.2 in) from the bottom of the filler plug hole. If th ...

© 2017-2024 Copyright www.sulegacy.com