1. Loosen the lock nut, and adjust the stop light switch position until the clearance (A) between the threaded end of the stop light switch and stopper becomes 1.1 mm (0.04 in). Then, tighten the lock nut. Tightening torque: 8 N·m (0.8 kgf-m, 5.9 ft-lb) 2. Tighten the lock nut.
|
Electrical specification
1. AUTO HEADLIGHT BEAM LEVELER CMTerminal No.ContentMeasuring conditionStandard1 ←> Chassis groundIgnition power supplyIgnition switch ON8 — 16 V2 ←> Chassis groundGNDAlwaysLess than 1 -3 ←> Chassis groundRr vehicle height sensor GNDAlwaysLess than 1 -4 — — — 5 — — — ...