1. Loosen the lock nut of the clutch start switch. 2. Fully depress the clutch pedal and hold it. 3. Adjust the gap (A) of the clutch pedal plate and the clutch start switch to be 2.9 mm (0.11 in).
4. Tighten the lock nut. Tightening torque: 8 N·m (0.8 kgf-m, 5.9 ft-lb) |
Dtc p2751 intermediate shaft speed sensor "c" circuit no signal
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Shifting shock is felt.• Acceleration is poor during standing start.• Shift control malfunction1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK FUSE ...