Subaru Legacy BN/BS (2015-2019) Service Manual: Adjustment
CAUTION: • CVTF level changes along with CVTF temperature. When inspecting CVTF level, observe the specified CVTF temperature. • Always use specified CVTF. Using other fluid will cause malfunction. 1. Start the engine to raise CVTF temperature to 35 — 45°C (95 — 113°F) on Subaru Select Monitor. 2. Operate the select lever in P > R > N > D and D > N > R > P to circulate CVTF with the engine idling. 3. With the engine idling, lift up the vehicle and remove the filler plug. CAUTION: Pay special attention to the following operations as the engine is at idle. NOTE: CVTF is at the specified level when it is up to the filler plug hole lower section.
4. When there is no CVTF leakage from the transmission, add the specified fluid up to the filler plug hole lower section. Specified fluid: General Description > SPECIFICATION CAUTION: Note that when CVTF is added up to the lower section of filler plug while the transmission is in cold condition, overfilling of CVTF occurs, causing the oil to spill out.
5. Install the filler plug. NOTE: Use a new gasket. Tightening torque: 50 N·m (5.1 kgf-m, 36.9 ft-lb) |
Condition check
NOTE:When replacing CVTF, determine the condition inside the transmission body by inspecting the drained CVTF.Fluid conditionTrouble and possible causeCorrective actionMetal particles.Excessive wear o ...
Replacement
CAUTION:• Directly after the vehicle has been running or the engine has been idling for a long time, the CVTF is hot. Be careful not to burn yourself.• Be careful not to spill the CVTF on ...
Other materials:
Dtc p2750 intermediate shaft speed sensor "c" circuit range/performance
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Shifting shock is felt.• Acceleration is poor during standing start.• Shift control malfunction1. ENGINE TYPE FBSTEPCHECKYESNO1.CHECK DTC.Read the DTC using Subaru Select Monitor.Besides DTC P2750, is any of ...
