1. Disconnect the ground terminal from battery sensor. NOTE 2. Release the shift lock using a screwdriver to shift the select lever to the “N” range. 3. Lift up the vehicle. 4. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL 5. Loosen the two bolts holding the inhibitor switch. 6. Insert the ST vertically into the holes of the shifter arm and switch body.
7. Tighten the two bolts holding the inhibitor switch. Tightening torque: 5 N·m (0.5 kgf-m, 3.7 ft-lb) 8. Repeat the inspection of the inhibitor switch. If the inhibitor switch is determined to be “faulty”, replace it. |
Dtc p0451 evap system (cpc) pressure sensor/switch circuit range/performance
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.STEPCHECKYESNO1.CHECK FOR ANY OTHER DTC ON DISPLAY.Is an ...