1. Disconnect the ground terminal from battery sensor. NOTE 2. Release the shift lock using a screwdriver to shift the select lever to the “N” range. 3. Remove the front exhaust pipe. Front Exhaust Pipe > REMOVAL 4. Remove the harness stay from transmission. 5. Loosen the two bolts holding the inhibitor switch. 6. Insert the ST vertically into the holes of the shifter arm and switch body.
7. Tighten the two bolts holding the inhibitor switch. Tightening torque: 5 N·m (0.5 kgf-m, 3.7 ft-lb) 8. Repeat the inspection of the inhibitor switch. If the inhibitor switch is determined to be “faulty”, replace it. |
Windshield washer fluid
CAUTION
Never use engine coolant as washer
fluid because it could cause paint
damage.
Windshield washer fluid warning indicator
When there is only a small amount of
washer fluid remaining, the windshield
washer fluid warning indicator will appear.
When this occurs, re ...