1. Check each part. Front Disc Brake Assembly > INSPECTION 2. Clean the inside of the caliper body using brake fluid. Fluid: FMVSS No. 116, DOT3 or DOT4 3. Install the piston seal and the piston - disc brake. (1) Apply a coat of brake fluid to piston seal and install the piston seal to the groove inside caliper body. (2) Apply a coat of brake fluid to the piston sliding part of caliper body and the entire outer surface of the piston - disc brake. Fluid: FMVSS No. 116, DOT3 or DOT4 (3) Apply a coat of grease to the piston boot and fit to the groove on the ends of piston - disc brake. Grease: An item contained in the piston seal kit or equivalent (4) Install the piston - disc brake to the caliper body. CAUTION: Do not force the piston - disc brake into the sliding part of caliper body.
4. Apply grease contained in the piston seal kit (or Nippon Grease NIGLUBE RX-2) to the lock pin - front brake, the outer surface of guide pin - front brake, the pin sliding part of the support - front disc brake, and the grooves of pin boot. Grease: An item contained in the piston seal kit or Nippon Grease NIGLUBE RX-2 5. Install the pin boot to the lock pin - front brake and the guide pin - front brake, and insert them into the support - front disc brake. CAUTION: Insert the lock pin - front brake and guide pin - front brake into specified position, and make sure that they slide and seat properly.
|
Dtc b1823 short in side airbag rh (to +b)
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Short circuit failure in power supply (shorted in main harness power supply, shorted in front seat side airbag RH power supply, shorted in airbag CM internal circuit power supply)CAUTION:Before performing diagnosis, r ...