NOTE: If the brake hose is disconnected, air enters inside. Therefore, this operation should be performed on the vehicle without the brake hose disconnected. 1. Check each part. Rear Disc Brake Assembly > INSPECTION 2. Install the bushing. 3. Using the ST, install the piston boot. Preparation tool: ST: PISTON BOOT INSTALLER (99099AL000) Grease: Nippon Grease NIGLUBE RX-2 |
Inspection
1. INSPECTION OF SWITCH UNIT1. Operate the switches to check the continuity between terminals.Preparation tool:Circuit testerSwitch positionTerminal No.StandardOFFA1 and A3Less than 1 -INTA1 and A3Less than 1 -LOA2 and A3Less than 1 -HIA2 and A4Less than 1 -Washer ONB2 and B3Less than 1 -2. Replace ...