1. Install the plugs. NOTE: • Use new O-rings. • Apply CVTF to the O-rings. Tightening torque: 25 N·m (2.5 kgf-m, 18.4 ft-lb) 2. Using ST, install the center support COMPL.
Tightening torque: 21.5 N·m (2.2 kgf-m, 15.9 ft-lb) |
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the air intake duct. (RH side only) Air Intake Duct > REMOVAL3. Disconnect the connector (A) from the camshaft position sensor, and remove the camshaft position sensor from the chain cover.• RH side• LH side ...