1. Using the ST, install the ball bearing to front reduction drive gear. NOTE: Use a new ball bearing.
2. Using ST1 and ST2, install the ball bearing to front reduction drive gear. NOTE: Use a new ball bearing.
3. Install the seal rings. NOTE: • Use new seal rings. • When installing the seal rings, do not expand the seal rings too much. • Install the O-ring when installing the torque converter assembly. |
Dtc p0843 transmission fluid pressure sensor/switch "a" circuit high
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:Shift characteristics malfunction1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK INPUT SIGNAL FOR TCM.1) Start the engine.2) Warm up until the ATF temperature reaches ...