Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly
1. RADIATOR MAIN FAN AND RADIATOR MAIN FAN MOTOR 1. Install the radiator main fan motor to the radiator fan shroud. Tightening torque: 3.9 N·m (0.4 kgf-m, 2.9 ft-lb) 2. Install the radiator main fan to the radiator main fan motor. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 3. Connect the connector to the radiator fan control module (main), and install the radiator main fan motor harness. 2. RADIATOR SUB FAN AND SUB FAN MOTOR 1. Install the radiator sub fan motor to the radiator fan shroud. Tightening torque: 3.9 N·m (0.4 kgf-m, 2.9 ft-lb) 2. Install the radiator sub fan to the radiator sub fan motor. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 3. Connect the connector to the radiator fan control module (sub), and install the radiator sub fan motor harness. 3. RADIATOR FAN HARNESS Set the radiator fan harness to the radiator fan shroud, and install the clip securing radiator fan harness.
4. RADIATOR FAN SHROUD 1. Install the radiator main fan and the radiator main fan motor. Radiator Fan and Fan Motor Assembly > ASSEMBLY 2. Install the radiator sub fan and the radiator sub fan motor. Radiator Fan and Fan Motor Assembly > ASSEMBLY 3. Install the radiator fan harness. Radiator Fan and Fan Motor Assembly > ASSEMBLY 4. Install the radiator fan control module. Radiator Fan Control Unit > INSTALLATION |
Removal
1. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) Carefully pull up the front of collector cover at two positions (B) while moving it forward.2. ...
Installation
1. Position the radiator fan & fan motor assembly, and install the radiator fan & fan motor assembly to the claw on the radiator upper side.2. Connect radiator inlet hoses LH and RH to the radiator.3. ...
Other materials:
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Remove the bolts, and then remove the panel - knee guard.4. Remove the motor - actuator mode.(1) Disconnect the connector.(2) Remove the s ...
