1. Install the hub unit COMPL - rear axle to the ST securely. Preparation tool: ST: HUB STAND (28099PA080)
2. Using a press, press new bolts - hub (b) until their seating surfaces contact the hub unit COMPL - rear axle (a). NOTE: Use the 12 mm (0.47 in) dia. holes in the HUB STAND to prevent bolts from tilting. |
Outback
Apply a flat-head screwdriver to the
light cover as shown in the illustration, and
pry the light cover off from the rear gate
trim.
Turn the bulb socket counterclockwise
and remove it.
Pull the bulb out of the bulb socket and
replace it with a new one.
Install ...