1. Install the fuel pipe assembly to the intake manifold assembly. Tightening torque: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb) 2. Install the fuel delivery pipe to the intake manifold assembly. CAUTION: • Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe. • When connecting the quick connector, make sure to insert it all the way in before locking the slider. • When it is difficult to lock the slider, check that the connector is fully inserted. • After locking the slider, check again that the quick connector is securely connected. NOTE: Connect the quick connector as shown in the figure.
3. Install the manifold absolute pressure sensor. Manifold Absolute Pressure Sensor > INSTALLATION 4. Install the purge control solenoid valve. Purge Control Solenoid Valve > INSTALLATION 5. Install the EGR control valve. EGR Control Valve > INSTALLATION 6. Install the EGR pipe. EGR Pipe > INSTALLATION 7. Install the throttle body. Throttle Body > INSTALLATION |
Profiles
This system supports the following services.
NOTE
If your cell phone does not support HFP, registering the
Bluetooth phone or using OPP, PBAP, MAP or SPP profiles
individually will not be possible.
If the connected Bluetooth device version is older than
recommended or in ...