Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly
CAUTION: Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb. 1. HIGH BEAM BULB 1. Install the high beam bulb. 2. Connect the connector. 2. LOW BEAM BULB (HALOGEN TYPE) 1. Install the low beam bulb. 2. Connect the connector. 3. LOW BEAM BULB (HID TYPE) 1. Install the low beam bulb. 2. Install the ballast - headlight. 4. SIDE MARKER LIGHT BULB 1. Install the side marker light bulb. 2. Install the bulb socket. 5. TURN SIGNAL LIGHT BULB 1. Install the turn signal light bulb. 2. Install the bulb socket. |
Disassembly
CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.1. HIGH BEAM BULB1. Disconnect the connector.2. Rotate in the direction of arrow shown in the figure t ...
Headlight bulb
...
Other materials:
Assembly
1. Using the ST, install the taper roller bearing (transfer case side).CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Be careful when handling because the taper roller bearing and the outer race are used as a set.ST 927640000INSTALLER(A)Taper roller bearing ( ...
