1. Install the needle bearing and snap ring to the transfer drive gear. 2. Set the ST to the ball bearing inner race, then install the transfer drive gear. CAUTION: Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton). NOTE: Use a new ball bearing.
3. Install the snap ring. 4. Inspect the clearance between the snap ring and the ball bearing. Transfer Drive Gear > INSPECTION |
Caution
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by a customer, record the memory contents before disconnecting the battery ground cable.& ...