Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly
1. Using the ST, install the taper roller bearing (transfer case side). CAUTION: Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton). NOTE: Be careful when handling because the taper roller bearing and the outer race are used as a set.
2. Using the ST, install the taper roller bearing (extension case side). CAUTION: Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton). NOTE: Be careful when handling because the taper roller bearing and the outer race are used as a set.
|
Removal
1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL3 ...
Installation
1. Install the taper roller bearing (transfer case side) outer race.(A)Taper roller bearing (transfer case side) outer race2. Apply a coat of grease to the taper roller bearing (transfer case side) of ...
Other materials:
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL4. Remove the center exhaust cover.5. Remove the clamp cable and take out the MT gear shift cable from the clamp.(A)Clamp cable6. Remove the dust cover. ...
