Subaru Legacy BN/BS (2015-2019) Service Manual: Assembly
1. FRONT 1. Insert the rubber assembly - windshield wiper onto the blade - windshield wiper so that the stopper is in the position shown in the figure.
2. Make sure the rubber assembly - windshield wiper is securely fastened to the pull stopper (A).
2. REAR 1. Insert the rubber assembly - rear wiper into claw (B).
2. Insert the rubber assembly - rear wiper until its top end protrudes approx. 20 mm (0.79 in) from stopper (D). 3. Insert the rubber assembly - rear wiper into claw (A).
|
Removal
1. FRONTNOTE:Since the arm assembly - windshield wiper LH and RH can interfere with each other, remove the driver’s side first.1. Lift up the locking clip (A).2. Turn the blade assembly - windsh ...
Installation
Install each part in the reverse order of removal.CAUTION:Make sure the locking clip is secured.NOTE:Since the arm assembly - windshield wiper LH and RH can interfere with each other, install the pass ...
Other materials:
When the rear gate cannot be closed
CAUTION
On areas which are not flat, such
as hills, do not conduct any of
the following actions. The rear
gate may close suddenly and hit
someone's head, face or catch
fingers and body parts in it,
resulting in injury.
Even while conducting the foll ...
