CAUTION: • Do not reuse hog rings. • Secure the hog ring using hog ring pliers. • Install the hog rings to the specified points securely and make sure that there is no wrinkle or twisting on the cover COMPL - rear backrest. 1. Install the seat heater module. CAUTION: • If the seat heater module and seating sensor are removed, replace the pad assembly with a new part. • If the seat heater module is reused, remove the polyurethane section from the reverse side completely and attach a new pad assembly with a double-sided tape. Double-sided tape: NITTO DENKO 501L or equivalent 2. Assemble the cover COMPL - rear backrest and the cover - rear cushion in the same manner as for the front seat. Front Seat > ASSEMBLY 3. Install the hog rings (A) on the back side of the rear seat cushion assembly. 4. Install the hog rings and wire clip, then install the cover COMPL - rear backrest LH. NOTE: • Do not contaminate or damage the cover COMPL - rear backrest and the cover - rear cushion. • While installing the hog rings, prevent the cover COMPL - rear backrest and the cover - rear cushion from getting wrinkled. 5. Install the plastic fastener and hog ring, and then install the headrest cover. 6. Install the pad assembly - main LH. 7. Install the bushing - headrest and the bushing - lock assembly. 8. Install the lock assembly - rear backrest rear LH. Tightening torque: 22.5 N·m (2.3 kgf-m, 16.6 ft-lb) 9. Install the plastic hooks on the back side of the backrest assembly LH. 10. Install the tether anchor cover. 11. Install the clips on the backside of the cover COMPL - rear backrest LH. 12. Install the knob - backrest. (Screw-in type) 13. Referring to the above steps, install the pad assembly - main RH. Tightening torque: Refer to “COMPONENT” of “General Description”. General Description > COMPONENT 14. Install the headrest assembly - rear. 15. Before installation, check the following items. • No tear and fray on the cover COMPL - rear backrest and the cover - rear cushion. • No fray or deformation on each wire cable. 16. Install the rear seat. Rear Seat > INSTALLATION |
Tire pressure warning light does not come on
DETECTING CONDITION:Defective combination meterTROUBLE SYMPTOM:When the ignition switch is turned to ON, the tire pressure warning light does not turn on (for approx. 2 seconds).STEPCHECKYESNO1.CHECK DTC.Read the DTC of tire pressure monitoring. Read Diagnostic Trouble Code (DTC)Is DTC displayed-Pe ...