Subaru Legacy BN/BS (2015-2019) Service Manual: Auto headlight beam leveler system (diagnostics)
Subaru Legacy BN/BS (2015-2019) Service Manual / Auto headlight beam leveler system (diagnostics)
- Basic diagnostic procedure procedure
- Check list for interview check
- Clear memory mode operation
- Diagnostics with phenomenon inspection
- Electrical component location location
- Inspection mode procedure
- List of diagnostic trouble code (dtc) list
- Read diagnostic trouble code (dtc) operation
- Control module i o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0074 control module communication bus "body-can" off
- Dtc b2902 rear height sensor circuit
- Dtc b2900 ahl control
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u1422 invalid data received from body control module body-can
- Dtc u1140 lost communication with body control module body-can
- General description
- Read current data
- Subaru select monitor
Installation
CAUTION:If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent the decline of the fixed force of the seat.1. Before install ...
Basic diagnostic procedure procedure
NOTE:Refer to STEERING RESPONSIVE FOG LIGHTS (DIAGNOSTICS) for models with steering responsive fog light system. Basic Diagnostic ProcedureSTEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check L ...
Other materials:
Installation
1. Clean the mating surface of oil pump chain cover and converter case cover.2. Using the ST, install the oil seal.ST 499755602PRESS SNAP RING3. Install the drive sprocket and install the snap ring.4. Place the oil pump chain on drive sprocket.5. Place the oil pump chain on driven sprocket and in ...
© 2017-2025 Copyright www.sulegacy.com
