Subaru Legacy BN/BS (2015-2019) Service Manual: Basic diagnostic procedure procedure

Subaru Legacy BN/BS (2015-2019) Service Manual / Engine (diagnostics)(h6do) / Basic diagnostic procedure procedure

1. ENGINE

STEP	CHECK	YES	NO
1.CHECK ENGINE START FAILURE. 1) Ask the customer when and how the trouble occurred using the interview check list. Check List for Interview > CHECK 2) Start the engine.	Does the engine start-	Basic Diagnostic Procedure > PROCEDURE	Inspection using “Diagnostics for Engine Starting Failure” Diagnostics for Engine Starting Failure
2.CHECK ILLUMINATION OF MALFUNCTION INDICATOR LIGHT.	Does the malfunction indicator light illuminate-	Basic Diagnostic Procedure > PROCEDURE	Inspection using “General Diagnostic Table”. General Diagnostic Table > INSPECTION
3.CHECK COMMUNICATION STATUS. 1) Turn the ignition switch to OFF. 2) Connect the Subaru Select Monitor or general scan tool to the data link connector. 3) Turn the ignition switch to ON, and run the Subaru Select Monitor or general scan tool. NOTE: • Subaru Select Monitor For detailed operation procedures, refer to the “Subaru Select Monitor”. Subaru Select Monitor • General scan tool For detailed operation procedures, refer to the general scan tool operation manual.	Does Subaru Select Monitor or general scan tool communicate with vehicle normally-	Basic Diagnostic Procedure > PROCEDURE	Inspection using LAN system “Diagnostic Procedure with Diagnostic Trouble Code (DTC)”. Basic Diagnostic Procedure
4.CHECK DTC. Read DTC using Subaru Select Monitor or general scan tool. NOTE: • Subaru Select Monitor For detailed operation procedures, refer to “Read Diagnostic Trouble Code (DTC)”. Read Diagnostic Trouble Code (DTC) • General scan tool For detailed operation procedures, refer to the general scan tool operation manual.	Is DTC displayed on Subaru Select Monitor or general scan tool-	Record the DTC and freeze frame data. Repair the trouble cause. List of Diagnostic Trouble Code (DTC) After repair, go to the next step. Basic Diagnostic Procedure > PROCEDURE	Repair the related parts. NOTE: If DTC is not shown on display although the malfunction indicator light illuminates, perform the diagnosis of malfunction indicator light circuit or combination meter. Malfunction Indicator Light
5.PERFORM DIAGNOSIS. 1) Perform the Clear Memory Mode. Clear Memory Mode 2) Perform the Inspection Mode or Drive Cycle. Inspection Mode Drive Cycle	Is DTC displayed on Subaru Select Monitor or general scan tool-	Inspect using “Diagnostic Procedure with Diagnostic Trouble Code (DTC)”. Diagnostic Procedure with Diagnostic Trouble Code (DTC)	Finish the diagnosis.

Active test operation

CAUTION:After executing the system operation check mode, execute the Clear Memory Mode. Clear Memory Mode > OPERATIONNOTE:For detailed operation procedures, refer to “Application help”.*: ...

Check list for interview check

1. CHECK LIST NO. 1Check the following item when problem has occurred.NOTE:Use copies of this page for interviewing customers.Customer’s name Engine No. Date of purchase Fuel type Date of repair ...

Other materials:

Installation
CAUTION:When the ECM of model with immobilizer has been replaced, be sure to perform the registration of immobilizer system. (Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER”.)NOTE:When replacing the ECM, be careful not to use the ECM of wrong specification to avoid any damage on the f ...