CAUTION: • Subaru Select Monitor is required for reading DTC, performing diagnosis and reading current data. • Remove foreign matter (dust, water, oil, etc.) from the body integrated unit connector during removal and installation. • Registration of immobilizer may be needed after the replacement of control modules, etc. For detailed procedure, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume. NOTE: • To check harness for open or short circuits, shake the suspected trouble spot or connector. • Check List for Interview Check List for Interview
|
If the light is blinking
If the light is blinking while driving, an
engine misfire condition has been detected
which may damage the emission
control system.
To prevent serious damage to the emission
control system, you should conform
to the following instructions.
Reduce vehicle speed.
Avoid hard a ...