Subaru Legacy BN/BS (2015-2019) Service Manual: Blind spot detection rear cross traffic alert (diagnostics)
Subaru Legacy BN/BS (2015-2019) Service Manual / Blind spot detection rear cross traffic alert (diagnostics)
- Basic diagnostic procedure procedure
- Check list for interview check
- Clear memory mode operation
- Diagnostic procedure with cancel code dtc b2328 rear radar internal failure (radar misalignment)
- Diagnostics with phenomenon inspection
- Electrical component location location
- Inspection mode operation
- List of cancel code list
- List of diagnostic trouble code (dtc) list
- Read cancel code operation
- Read diagnostic trouble code (dtc) operation
- Control module i o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u0073 control module communication bus off
- Dtc u0101 lost communication with tcm
- Dtc u0423 invalid data received from instrument panel cluster control module
- Dtc u0422 invalid data received from body control module
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0402 invalid data received from tcm
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc b2350 rear radar communication error between master and slave
- Dtc b2329 rear radar axis alignment incomplete
- Dtc b2327 rear radar internal failure (internal electric circuit)
- Dtc b2313 rear radar detect vdc
- Dtc b2311 rear radar detect tcm
- Dtc b2304 rear radar on-off switch stuck
- Dtc b2301 rear radar circuit high
- Dtc b2300 rear radar circuit low
- Dtc u0140 lost communication with body control module
- Dtc u0122 lost communication with vehicle dynamics control module
- General description
- Read current data
- Subaru select monitor
- System operation check mode
Inspection
1. COMMUNICATION FOR INITIALIZING IMPOSSIBLECommunication error with auto headlight beam leveler CMDETECTING CONDITION:• Defective harness connector• Power supply circuit malfunction• ...
Basic diagnostic procedure procedure
STEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check List for Interview, ask the customer the condition of how trouble occurs.Did you interview the customer- Basic Diagnostic Procedure > PROCEDU ...
Other materials:
Installation
1. RH SIDE1. Set the fuel injector to the fuel injector pipe RH, and install the fuel injector pipe RH and fuel injector as a unit to the cylinder head.NOTE:Use new O-rings, rubbers and seal rings.2. Install the bolts securing the fuel injector pipe to the cylinder head, and connect the connector (A ...
© 2017-2025 Copyright www.sulegacy.com
