Subaru Legacy BN/BS (2015-2019) Service Manual: Caution

Subaru Legacy BN/BS (2015-2019) Service Manual / Control systems / General description / Caution

• Remove contamination including dirt and corrosion before removal, installation or disassembly.

• Keep the disassembled parts in order and protect them from dust and dirt.

• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly and replacement.

• Use SUBARU genuine fluid, grease etc. or equivalent. Do not mix fluid, grease, etc. of different grades or manufacturers.

• Be sure to tighten fasteners including bolts and nuts to the specified torque.

• Place shop jacks or rigid racks at the specified points.

• Apply grease onto sliding or revolving surfaces before installation.

• Before installing O-rings or snap rings, apply sufficient amount of grease to avoid damage and deformation.

• Before securing a part in a vise, place cushioning material such as wood blocks, aluminum plate or cloth between the part and the vise.

• Before disconnecting electrical connectors, be sure to disconnect the negative terminal from battery.

Preparation tool

1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — (Newly adopted tool)SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed op ...

Component

1. AT SELECT LEVER(1)Grip ASSY(8)Cushion solenoid(15)Nut(2)Clamp grip pin(9)Solenoid unit (3)Rod COMPL(10)Selector lever COMPLTightening torque: N·m (kgf-m, ft-lb)(4)Cover grip AT(11)Snap pinT ...

Other materials:

Installation
1. Install the glass - front door partition.2. Install the running channel - front door and the sash assembly - partition.CAUTION:Check that the running channel - front door is securely fixed to the panel assembly - front door and to the sash assembly - partition.Tightening torque:Refer to “CO ...