Subaru Legacy BN/BS (2015-2019) Service Manual: Caution
1. AIRBAG SYSTEM Airbag system wiring harness is routed near the cruise control command switch. CAUTION: • Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits. • Be careful not to damage the airbag system wiring harness when servicing the cruise control command switch. 2. EyeSight CAUTION: • Do not hold the camera unit of the stereo camera. • Do not touch the lens on the stereo camera. • Do not clean the lens of the stereo camera. • When cleaning the windshield glass, use care so that the glass cleaner, etc. does not come in contact with the lens of the stereo camera. • Do not make an impact or apply excessive force to the stereo camera. • Do not disassemble the stereo camera. • Do not change the installation position of the stereo camera or do not modify the surrounding structure. • If the stereo camera or windshield glass is removed or replaced, always adjust or check the stereo camera. • When lifting up the vehicle to rotate the tires, turn off the pre-crash function. • Stereo camera axis may be displaced even in a minor collision. So be sure to adjust the stereo camera even when the EyeSight warning light is not illuminated or when the “Stereo Camera Temporary Stop” is not displayed on the multi-information display. • When removing the stereo camera cover assembly, cover it with a copy paper or similar dust-free paper to avoid any interference to the camera lens, and tape the paper while being careful not to let the adhesive surface contact the glass surface. Be sure to remove the paper after the procedure. Stereo Camera > REMOVAL |
Preparation tool
1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — (Newly adopted tool)SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed op ...
Inspection
1. BATTERYCheck the battery. Battery Battery2. WINDSHIELD GLASS AND DASHBOARDRemove the windshield glass and dashboard in front of the stereo camera.Standard:There must be no oil film, dirt, scratch ...
Other materials:
Operating the rear passenger's windows
To open:
Press the switch down and hold it until the
window reaches the desired position.
To close:
Pull the switch up and hold it until the
window reaches the desired position.
When the lock switch on the power
window switch cluster, located on the
driver's side door, is in the lock ...
