• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by a customer, record the memory contents before disconnecting the battery ground cable. • Be careful of the following items. Failing to do so may cause the airbag system malfunction. – Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of “AIRBAG SYSTEM”. General Description > CAUTION – Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column. • When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT • If the damage is found in the glass repair prohibited area, always replace the glass. General Description > INSPECTION Damage in the prohibited area can affect the recognition of the stereo camera even if it is repaired, and thereby EyeSight function may not operate properly. • When the suspension-related components have been removed, installed or replaced, or the wheel alignment is adjusted, perform “Clear Active Lane Keep System Learning Value”. Clear Active Lane Keep System Learning Value > OPERATION |
Note
For procedure of each component in the combination meter system, refer to the respective section.• Combination meter assembly: Combination Meter• Speedometer: Speedometer• Tachometer: Tachometer• Fuel gauge: Fuel Gauge• Engine coolant temperature gauge: Engine Cool ...